Sunday, 12 February 2017

LOVE Word Tile Card - Hobbybase Guest DT

Hello I'm back to share another Valentines or LOVE Card Step by Step with you. This card is suitable for all those 'Love' occasions.  For this design I am using the stamp whole and also cutting into it to create individual letter tiles.  Again 3D foam pads create a raised and tactile effect.

Step By Step:

I created this design for +Hobbybase Ltd. as a Guest on their Design Team, all products can be found online at (product links at end of post)

Score & fold white card or trim down a 6x6 white card blank to create a 12.5cm square card base with fold across the top. 

Cut a slightly smaller square of dark grey pattern ‘Made with Love’ paper and adhere to card front using double sided tape.  Cut a 10.5cm square of dark pink pattern paper and mat onto card front.

Cut a 3cm deep strip of dark grey pattern paper and adhere across centre of card front using d/s tape. trim ends flush with card.

Using black ink, stamp the LOVE letter tile stamp onto grey heart paper and cut the whole word out. Use 3D foam pads to adhere to strip towards Left side.

Using black ink stamp the Love letter tile stamp again, this time cut out each individual letter.  Adhere the letters randomly at angles, above and below the centre panel, using 3D foam pads

To finish, die cut hearts from different ‘Made with love’ papers using both of the Dovecraft heart dies.  Mount the smaller heart on top of the larger one, then glue across card strip at right of LOVE sentiment.


Products Used:
Black Ink
White Card
Adhesives: D/S Tape, Clear Drying Glue, 3D Foam

No comments:

Post a Comment